Tested of nse4 dumps test engine materials and secret for Fortinet certification for customers, Real Success Guaranteed with Updated nse4 dumps pdf dumps vce Materials. 100% PASS Fortinet Network Security Expert 4 Written Exam (400) exam Today!

Q51. - (Topic 15) 

Review the IKE debug output for IPsec shown in the exhibit below. 

Which statements is correct regarding this output? 

A. The output is a phase 1 negotiation. 

B. The output is a phase 2 negotiation. 

C. The output captures the dead peer detection messages. 

D. The output captures the dead gateway detection packets. 

Answer:


Q52. - (Topic 8) 

Examine the following FortiGate web proxy configuration; then answer the question below: config web-proxy explicit set pac-file-server-status enable set pac-file-server-port 8080 set pac-file-name wpad.dat end Assuming that the FortiGate proxy IP address is 10.10.1.1, which URL must an Internet 

browser use to download the PAC file? 

A. https://10.10.1.1:8080 

B. https://10.10.1.1:8080/wpad.dat 

C. http://10.10.1.1:8080/ 

D. http://10.10.1.1:8080/wpad.dat 

Answer:


Q53. - (Topic 4) 

Which two statements are true regarding firewall policy disclaimers? (Choose two.) 

A. They cannot be used in combination with user authentication. 

B. They can only be applied to wireless interfaces. 

C. Users must accept the disclaimer to continue. 

D. The disclaimer page is customizable. 

Answer: C,D 


Q54. - (Topic 19) 

Data leak prevention archiving gives the ability to store files and message data onto a 

FortiAnalyzer unit for which of the following types of network traffic? (Choose three.) 

A. POP3 

B. SNMP 

C. IPsec 

D. SMTP 

E. HTTP 

Answer: A,D,E 


Q55. - (Topic 13) 

Which statements are correct for port pairing and forwarding domains? (Choose two.) 

A. They both create separate broadcast domains. 

B. Port Pairing works only for physical interfaces. 

C. Forwarding Domain only applies to virtual interfaces. 

D. They may contain physical and/or virtual interfaces. 

Answer: A,D 


Q56. - (Topic 10) 

How do you configure a FortiGate to apply traffic shaping to P2P traffic, such as BitTorrent? 

A. Apply a traffic shaper to a BitTorrent entry in an application control list, which is then applied to a firewall policy. 

B. Enable the shape option in a firewall policy with service set to BitTorrent. 

C. Define a DLP rule to match against BitTorrent traffic and include the rule in a DLP sensor with traffic shaping enabled. 

D. Apply a traffic shaper to a protocol options profile. 

Answer:


Q57. - (Topic 6) 

You are the administrator in charge of a FortiGate acting as an IPsec VPN gateway using route-based mode. Users from either side must be able to initiate new sessions. There is only 1 subnet at either end and the FortiGate already has a default route. 

Which two configuration steps are required to achieve these objectives? (Choose two.) 

A. Create one firewall policy. 

B. Create two firewall policies. 

C. Add a route to the remote subnet. 

D. Add two IPsec phases 2. 

Answer: B,C 


Q58. - (Topic 7) 

Which antivirus inspection mode must be used to scan SMTP, FTP, POP3 and SMB protocols? 

A. Proxy-based. 

B. DNS-based. 

C. Flow-based. 

D. Man-in-the-middle. 

Answer:


Q59. - (Topic 5) 

Which two statements are true about IPsec VPNs and SSL VPNs? (Choose two.) 

A. SSL VPN creates a HTTPS connection. IPsec does not. 

B. Both SSL VPNs and IPsec VPNs are standard protocols. 

C. Either a SSL VPN or an IPsec VPN can be established between two FortiGate devices. 

D. Either a SSL VPN or an IPsec VPN can be established between an end-user workstation and a FortiGate device. 

Answer: A,D 


Q60. - (Topic 13) 

Which statements correctly describe transparent mode operation? (Choose three.) 

A. The FortiGate acts as transparent bridge and forwards traffic at Layer-2. 

B. Ethernet packets are forwarded based on destination MAC addresses, NOT IP addresses. 

C. The transparent FortiGate is clearly visible to network hosts in an IP trace route. 

D. Permits inline traffic inspection and firewalling without changing the IP scheme of the network. 

E. All interfaces of the transparent mode FortiGate device must be on different IP subnets. 

Answer: A,B,D