Precise of 400 101 dumps actual test materials and training materials for Cisco certification for consumer, Real Success Guaranteed with Updated ccie 400 101 pdf dumps vce Materials. 100% PASS CCIE Routing and Switching (v5.0) exam Today!

P.S. Precise 400-101 training materials are available on Google Drive, GET MORE: https://drive.google.com/open?id=1aa23iCS9y8wbMWn2hGy0qQPa-osDGBq3


New Cisco 400-101 Exam Dumps Collection (Question 12 - Question 21)

New Questions 12

Which protocol enables routers in an MPLS environment to use labels to move traffic?

A. FTP

B. POP

C. LLDP

D. PPP

E. L2TP

F. LOP

Answer: F


New Questions 13

Which two statements about LDP are true? (Choose two)

A. LDP sessions are established between LSRs

B. It enables LSRs to communicate label bindings

C. It sends hello messages over TCP

D. It uses a 16-byte identifier

E. It supports only directed-connected neighbors

F. It sends hello messages as UDP packets via unicast

Answer: A,B


New Questions 14

Which technology allows several switches to operate together as one device?

A. HSRP

B. VRRP

C. LACP

D. Stack Wise.

Answer: D


New Questions 15

What mechanism should you choose to prevent unicast flooding?

A. Make sure that all end systems are connected to the network with a single physical connection.

B. Use control plane policing (CPP) to limit unicast flooding.

C. Configure the ARP cache timers to be longer than the switch forwarding cache (CAM) timers.

D. Configure the switch forwarding cache (CAM) timers to be longer than the ARP cache timers.

Answer: D


New Questions 16

Which two statements about QoS and marking are true? (Choose two)

A. The set-discard-class command can be configured for ATM and MPLS protocols

B. It can use a table map to mark traffic

C. It requires Cisco Express forwarding to be enabled on the sending interface and the receiving interface

D. It is supported on tunnel interfaces

E. It is supported on Fast EthernetChannel and ATM SVC interfaces

Answer: A,D


New Questions 17

Ping and Traceroute extended options are very useful. What is the difference between using the Record option with the ping command vs. the traceroute command?

A. The record option is not supported with the ping command

B. The record option is not supported with the traceroute command

C. When leveraged with the ping command, the Record option of this command not only informs you of the hops that the echo request (ping) went through to get the destination, but is also informs you of the hops it visited on the return path

D. When leveraged with the traceroute command, the Record option of this command not only informs you of the hops that the echo request (ping) went through to get the destination, but is also informs you of the hops it visited on the return path

Answer: C


New Questions 18

Which two statements about HDLC operations in asynchronous balanced mode are true? (Choose two.)

A. Either device can send frames at any time.

B. Each device must negotiate with its neighbor before sending frames.

C. Each device must negotiate with its neighbor to recover from framing errors.

D. Either device can initiate transmission of frames.

E. The initiating device sends a DTE frame.

Answer: C,D


New Questions 19

Which two statements about CEF polarization are true? (Choose two)

A. The AND operation is performed on the higher-order bits of the source and destination IP address

B. A single link is chosen for all flows

C. The AND operation is performed on the lower-order bits of the source and destination IP address

D. After the XOR process, the flow is processed in the distribution Layer with a different hashing algorithm

E. It can be prevented by alternating the hashing inputs

F. When enabled, it allows all links to be used efficiently for different traffic flows

Answer: B,E


New Questions 20

Which options is the implicit access rule for IPv6 ACLs?

A. permit all

B permit neighbor discovery, deny everything else

B. deny all

C. permit all ICMP, deny everything else

Answer: B


New Questions 21

Refer to the exhibit.

Which traffic gets set to AF41 by marking policy on interface GigabitEthernet0/0?

A. Any traffic matching access-list-tp-rooms and access-list stream in g.

B. No Traffic gets set to AF41.

C. Only traffic matching access-list tp-rooms.

D. Only traffic matching access-list streaming.

Answer: A


100% Renew Cisco 400-101 Questions & Answers shared by Certifytools, Get HERE: https://www.certifytools.com/400-101-exam.html (New 911 Q&As)