Actualtests offers free demo for cisco 400 101 exam. "CCIE Routing and Switching (v5.0)", also known as 400 101 vce exam, is a Cisco Certification. This set of posts, Passing the Cisco passleader 400 101 exam, will help you answer those questions. The ccie 400 101 dumps Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco passleader 400 101 exams and revised by experts!

P.S. Vivid 400-101 bundle are available on Google Drive, GET MORE: https://drive.google.com/open?id=10qRl3c2aPM7jDirL_NepQ9ytoJQZm2pM


New Cisco 400-101 Exam Dumps Collection (Question 11 - Question 20)

New Questions 11

Which two statements about IPv6 6to4 tunnels are true? (Choose two)

A. Sites use addresses from the 2002::/16 prefix

B. Sites use addresses from link-local scope

C. They are point-to-multipoint tunnels

D. They are point-to-point tunnels

E. They rely on GRE encapsulation

Answer: A,C


New Questions 12

Which IPv6 tunneling mechanism requires a service provider to nude one of its own native IPv6 blocks to guarantee that its IPv6 hosts will be reachable?

A. 6rd tunneling

B. Automatic 6to4 tunneling

C. manual ipv6ip tunneling

D. NAT-PT tunneling

E. Automatic 4to6 tunneling

F. ISATAP tunneling

Answer: F


New Questions 13

Which two statements about MLD snooping are true?

A. MLD protocol messages can be sent in both IGMPv4 and ICMPv4 formats.

B. It supports private VLANs.

C. It limits the Layer 2 multicast traffic that is generate by routing protocols.

D. PFC modes support MLD version 2 only.

E. The MLD snooping querier requires the VLAN interface to be configured with an 1Pv6 address.

Answer: B,E


New Questions 14

Refer to the Exhibit.

What is the effect of the given configuration?

A. The router stops SNMP logging.

B. The router logs messages only to the console.

C. The router stops logging messages to the syslog server only.

D. The router log message only to the buffer.

Answer: C


New Questions 15

Refer to exhibit:

Which two statements about the output are true? (Choose two.)

A. 802.1D spanning tree is being used.

B. Setting the priority of this switch to 0 for VLAN 1 would cause it to become the new root.

C. The hello, max-age, and forward delay timers are not set to their default values.

D. Spanning-tree PortFast is enabled on GigabitEthernet1/1.

Answer: A,B

Explanation:

802.1D is the standard for Spanning tree, which is being used here. For priority, The priority order starts from 0 (yes, 0 is valid) and then increases in 4096.

0, 4096, 8192, 12288, u2026. Etc.

The lower the number is, the higher is the priority. Here we see that the current root has a priority of 8192, so configuring this with a priority of 0 will make it the new root.


New Questions 16

Which technology must be enabled on an interface before L2TPv3 can operate correctly?

A. OSPF

B. MPLS

C. CEF

D. STP

Answer: C


New Questions 17

What characteristic of OSPFv3 LSAs enables support for prefix suppression?

A. Router-LSAs and Network-LSAs do not contain topology information

B. Router LSAs and Network-LSAs do not contain prefix information

C. Router-LSAs and Network-LSAs are flooded into the entire OSPF domain

D. Router-LSAs and Network-LSAs are flooded only on the local link

Answer: B


New Questions 18

Refer to the exhibit. What is the meaning of the asterisk (*) in the LSP Seq Num column of this "show isis database" output?

A. The LSP originated on a router with an invalid hold time

B. The LSP originated on a L1-L2 type router

C. The LSP originated on the router where the command is being executed

D. The LSP originated on a router which is capable of wide metrics

Answer: D


New Questions 19

When you deploy DMVPN, What is the purpose of the command key cisco test address 0.0.0.0.0.0.0.0.?

A. lt is configured on the hub and spoke routers to establish peering

B. It is configured on the hub to set the pre-shared key for the spoke routers.

C. It is configured on the internet PE routers to traverse the ISP core.

D. lt is configured on the spokes to router.

Answer: B


New Questions 20

Which tunnel type can be used with encryption to provide security for IPv6 over IPv4?

A. 6RD

B. 6to4

C. ISATAP

D. IPv4-compatible

E. GRE

Answer: E


Recommend!! Get the Vivid 400-101 dumps in VCE and PDF From Certleader, Welcome to download: https://www.certleader.com/400-101-dumps.html (New 911 Q&As Version)