Exact of 300-365 exam answers materials and practice for Cisco certification for IT engineers, Real Success Guaranteed with Updated 300-365 pdf dumps vce Materials. 100% PASS Deploying Cisco Wireless Enterprise Networks exam Today!

Q31. A network engineer is viewing the QBSS information in a packet sniff. Which two QBSS characteristics are crucial for successful troubleshooting? (Choose two.) 

A. When only WMM is enabled, information element number 1 QBSS Load information element is sent out in the beacons and probe responses. 

B. When only WMM is enabled, information element number 3 QBSS Load information element is sent out in the beacons and probe responses. 

C. When the client CAC limit is supported, information element number 2 is sent out in the beacons and probe responses on the bg radios. 

D. When the client CAC limit is supported, information element number 1 is sent out in the beacons and probe responses on the bg radios. 

E. When only WMM is enabled, information element number 2 QBSS Load information element is sent out in the beacons and probe responses. 

Answer: D,E 


Q32. After a wireless deployment, users report that wireless voice clients are experiencing an unacceptable amount of delay while roaming during a call on the Cisco Unified 7925 Series phones. The customer environment consists of multiple controllers, all running 7.4.121.0 code, operating in a centralized deployment. What configuration issue is most likely contributing to the problem? 

A. The authentication should be set to WPA2-PSK to allow for 802.11n speeds for the Cisco Unified 7925 phones. 

B. The access points on that floor are all on one controller and should be load balanced evenly across multiple controllers. 

C. The access points for that floor are salt and peppered across multiple controllers and should be moved to the primary controller. 

D. The wireless phones are operating in the 2 4 GHz band and should be configured for the 5 GHz band. 

Answer:


Q33. A customer requires that an SSID is broadcasted to specific access points that use certain interfaces. Which feature can be used to achieve this goal? 

A. mobility groups 

B. flex-connect groups 

C. interface groups 

D. AP groups 

Answer:


Q34. RAG DROP 

Drag the QoS values from the left and drop them in the correct descending order of priority on the right. 

Answer: 


Q35. A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu utilization and wired side network load has increased substantially. What three actions should the engineer take next to optimize the configuration? (Choose Three) 

A. verify that Global Multicast mode has been enabled 

B. verify that IGMP snooping is disabled on the wireless controller since the access points are handing IGMP messages from the clients. 

C. make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth 

D. verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows 

E. change the wireless controller from Multicast-Unicastmodeto Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet 

F. verify that the L3 interfaces are configured for pirn sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller’s management VLAN 

Answer: A,B,E 


Q36. On which AP radio or radios is Cisco WGB association supported? 

A. 2.4 GHz only 

B. 2.4 or 5 GHz only 

C. 2.4, 5, or 4.9 GHz 

D. 5 GHz only 

Answer: