Master the 300-365 Deploying Cisco Wireless Enterprise Networks content and be ready for exam day success quickly with this Examcollection 300-365 free question. We guarantee it!We make it a reality and give you real 300-365 questions in our Cisco 300-365 braindumps.Latest 100% VALID Cisco 300-365 Exam Questions Dumps at below page. You can use our Cisco 300-365 braindumps and pass your exam.
Q21. A WLAN engineer has been asked to upgrade the software on a MSE 3365 Appliance. The engineer cannot access the system using the root password and the Grub password as the details had never been documented. How should the engineer perform the password recovery?
A. Use a console cable.
B. Contact Cisco TAC and arrange an RMA of the MSE.
C. Boot the MSE using the software installation DVD.
D. The Password can be reset using Prime Infrastructure.
Q22. A customer called into the support center with a problem ticket that involves wireless clients having to reauthenticate when they are walking around their office. After further investigation, it was discovered that the customer has two controllers in an N+1 deployment. Which action must the engineer take to troubleshoot the issue?
A. Verify that the wireless controllers are in the same mobility group and that the access points are all on the primary controller.
B. Under the SSID, make sure that 802.1 Iris configured and running for the clients.
C. Make sure that the SSID has the authentication set to 802.1x with Cisco Centralized Key Management so the data clients can roam seamlessly.
D. Verify the access points are spread out between the primary and secondary controller and that the controllers are in the same mobility group.
Q23. A network engineer has installed 802.11ac access points with 80 MHz enabled; however, in the conference rooms, co-channel interference is being noticed. Under which tab in the RF profiles configuration can the engineer find the settings to tune the channel width for a group of APs?
C. High Density
Q24. The customer has deployed C7960 phones with clients connected to them. What switch feature could be enabled to distinguish IP voice traffic from client data traffic?
B. QoS routing
D. Weighted Queuing
Q25. Which two options are limitations of using an AP as a workgroup bridge? (Choose two.)
A. Only factory-configured MAPs can support WGB mode.
B. MAPs that are configured in WGB mode do not answer S36 radio measurement requests.
C. A limited subset of Layer 2 security types are supported for wireless clients of a WGB.
D. There is a limit of 20 wired client devices.
E. Multiple VLANs are not supported for wireless clients.
Q26. When a Vocera badge performs a broadcast call in a properly configured VoWLAN using WLC v7.0, which two choices indicate how the QoS is marked? (Choose two.)
A. Upstream marked as Best Effort.
B. Upstream marked as ToS CS4.
C. Upstream marked as DSCP EF.
D. Downstream marked as DSCP EF.
E. Downstream marked as Best Effort.
F. Downstream marked as Silver.
Q27. A network engineer is experiencing issues enabling LAG on the WLC. Which four characteristics should be validated to ensure LAG configuration? (Choose four.)
A. All ports participate in the LAG by default when LAG is enabled on the controller, y
B. Dynamic interfaces and management are moved to port 1
C. Primary and secondary ports are needed for each interface.
D. Multiple untagged interfaces to the same port are not allowed.
E. EtherChannel must be configured for mode "on" on the switch.
F. Only one functional physical port is needed to continue to pass traffic.
G. Multiple LAGs are permitted on the controller.
H. The WLC does not need to be rebooted to enable the LAG configuration.
Q28. A customer requires that the remote site be able to utilize local servers when the AP is in WAN-down (standalone mode). Which AP mode must be configured on the wireless controller?
F. Rogue Detector
Q29. CMX Facebook WiFi can allow access to the network before authentication. Which two of the following options are available? (Choose two)
A. Allow all the traffic before authentication and intercept HTTPs only.
B. Allow HTTP traffic only before authentication and block all the traffic.
C. Allow SNMP traffic only before authentication and block all the traffic.
D. Allow all the traffic before authentication and intercept HTTP only.
E. Allow HTTPs traffic only before authentication and block all other traffic.
Q30. What devices can be tracked with the Cisco Context Aware Services?
A. Only wired devices.
B. Both wired and wireless devices.
C. Only Cisco certified wireless devices.
D. Only wireless devices.