Your success in Cisco 300-365 is our sole target and we develop all our 300-365 braindumps in a way that facilitates the attainment of this target. Not only is our 300-365 study material the best you can find, it is also the most detailed and the most updated. 300-365 Practice Exams for Cisco CCNP Wireless 300-365 are written to the highest standards of technical accuracy.

Q1. A customer requires wireless traffic from the branch to be routed through the firewall at corporate headquarters. There is a RADIUS server in each branch location. Which FlexConnect state should be used in this scenario? 

A. local authentication and local switching 

B. local authentication and central switching 

C. central authentication and central switching 

D. central authentication and local switching 

Answer:


Q2. A wireless engineer wants to enable optimized roaming for their 5GHz wireless network with these settings: -72dBm RSSI value, 25% coverage exception level percentage, and a minimum of 50 packets received. 

Which two commands achieve these settings? (Choose two.) 

A. config advanced 802.11a coverage data fail-percentage 25 

B. config advanced 802.11b optimized-roaming enable 

C. config advanced 802.11b coverage data rssi-threshold -72 

D. config advanced 802.11a optimized-roaming enable 

E. config advanced 802.11a coverage data rssi-threshold -72 

Answer: A,D 


Q3. An engineer wants to configure Call Admission Control and ensure that AC is based on the capacity of the AP and considering the possible impact of other APs in the area. Which two configuration options are required? (Choose two.) 

A. StaticCAC 

B. Admission Control 

C. Load-Based AC 

D. Add Traffic Stream 

E. Reserved Roaming Bandwidth 

F. Expedited Bandwidth 

Answer: B,C 


Q4. A network engineer is debugging issues with the mDNS gateway. Which type of reply should be seen in the Wireshark capture when querying for a mDNS service in the Bonjour Cache? 

A. unicast from Prime Infrastructure 

B. unicast from controller 

C. multicast from devices 

D. multicast from controller 

E. unicast from devices 

F. multicast from Prime Infrastructure 

Answer:


Q5. A customer is implementing a massively scaled guest wireless network to support approximately 32,000 clients. For ease of administration, they have required implementing multiple interfaces defined on the WLC and mapped to a single interface group. Which configuration meets this need? 

A. 264 interfaces of/25 sized networks 

B. 132 interfaces of/24 sized networks 

C. 66 interfaces of/23 sized networks 

D. 33 interfaces of /22 sized networks 

Answer:


Q6. Refer to Exhibit. 

A wireless client is connecting to FlexAPI which is currently working standalone mode. The AAA authentication process is returning the following AVPs: 

Tunnel-Private-Group-ld(81): 15 Tunnel-Medium-Type(65):IEEE-802(6) Tunnel-Type(64): VLAN(13) 

Which three behaviors will the client experience? (Choose three.) 

A. While the AP is in standalone mode, the client will be placed in VLAN 15. 

B. While the AP is in standalone mode, the client will be placed in VLAN 10. 

C. When the AP transitions to connected mode, the client will be de-authenticated. 

D. While the AP is in standalone mode, the client will be placed in VLAN 13. 

E. When the AP is in connected mode, the client will be placed in VLAN 13. 

F. When the AP transitions to connected mode the client will remain associated. 

G. When the AP is in connected mode, the client will be placed in VLAN 15. 

H. When the AP is in connected mode, the client will be placed in VLAN 10. 

Answer: A,D,E 


Q7. You have a VoWLAN configured for platinum QoS, WMM, and CAC. IP phones for this VoWLAN include the Nokia and Cisco Unified Wireless IP Phones 7920G (pre-v2.0 firmware), 7921G, and 7925G. The Wireless IP Phones 7921G and 7925G work properly, but the Nokia and the Wireless IP Phones 7920G associate with the WLAN but cannot place calls. What is the issue? 

A. The lowest mandatory speed in the WLAN is too high and needs to be reduced. 

B. The Cisco Unified Wireless IP Phones 7920G and Nokia IP phones do not support TSPEC. 

C. EDCA needs to be enabled on the WLAN. 

D. HCCA needs to be enabled on the WLAN. 

E. The reserved roaming bandwidth setting is set too low. 

F. The expedited bandwidth setting needs to be enabled. 

Answer:


Q8. Which network is connected by default when connecting to the unused Ethernet port of a MAP? 

A. the native VLAN that the MAP is connected to 

B. the VLAN that is associated with WLAN number 1 in the WLC 

C. the native VLAN that the WLC is connected to 

D. the VLAN that is associated with the SSID that the MAPs are communicating on 

Answer:


Q9. An engineer must deploy FlexConnect APs to a site that typically has 300 ms latency to the WLC. Which typical operating mode must the engineer plan on for normal operations? 

A. local authentication, local switching 

B. central authentication, central switching 

C. central authentication, local switching 

D. connected mode 

Answer:


Q10. A customer has implemented a N+1 high availability plan in a multistory building. All APs on odd numbered floors are set as primary to WLC-A and all APs on even numbered floors are set as primary to WLC-8. Which two problems are likely to arise from this design? (Choose two) 

A. inconsistent CleanAir data due to multiple WLCs 

B. floor-to-floor bleed-through that causes intercontroller roaming delays 

C. AVC inconsistency due to multiple mobility group members 

D. legacy device compatibility with multiple WLC configuration that causes disconnects 

E. unpredictable AP loading during a WLC failure 

Answer: A,C