we provide Simulation Cisco 300-365 braindumps which are the best for clearing 300-365 test, and to get certified by Cisco Deploying Cisco Wireless Enterprise Networks. The 300-365 Questions & Answers covers all the knowledge points of the real 300-365 exam. Crack your Cisco 300-365 Exam with latest dumps, guaranteed!

Q11. An engineer would like to capture NetFlowdata on PI. Which resource is required to allow this? 

A. Cisco MSE as NetFlow exporter 

B. Prime Infrastructure 1.0 or later 

C. Cisco NAC as NetFlow exporter 

D. Cisco ISE as NetFlow exporter 

Answer:


Q12. A wireless engineer at a convention center has been asked to provision an SSID that can accommodate 4,000 users during a conference. Which interface group configuration should be used? 

A. One interface with /20 mask 

B. Two interfaces with /21 mask 

C. Four interfaces with /22 mask 

D. Eight interfaces with /23 mask 

Answer:


Q13. A corporation has a Cisco Unified Wireless Network that has been deployed for voice coverage. The wireless data rates have been tuned to mandatory rates of 18 Mbps and 36 Mbps. Some wireless clients have been experiencing drops streaming multicast video while moving throughout the building. What is the cause of the drop in video? 

A. Clients are roaming at lower data rates and are not maintaining 36Mbps connectivity. 

B. Clients are not roaming due to coverage. This is causing the multicast data to drop due to the client re-associating often. 

C. Clients are connected at 18Mbps; however, other clients are connecting at 12Mbps and are causing the multicast video to degrade. 

D. Clients are maintaining a 12Mbps rate and cannot receive the stream at 18Mbps. 

Answer:


Q14. Which of the following is not a Cisco RF fingerprinting key advantage over Location Tracking? 

A. Uses existing LWAPP-enabled Cisco Unified Networking components. 

B. Proprietary client hardware or software is required. 

C. Better accuracy and precision. 

D. Reduced calibration effort. 

Answer:


Q15. A network engineer is viewing the QBSS information in a packet sniff. Which two QBSS characteristics are crucial for successful troubleshooting? (Choose two.) 

A. When only WMM is enabled, information element number 1 QBSS Load information element is sent out in the beacons and probe responses. 

B. When only WMM is enabled, information element number 3 QBSS Load information element is sent out in the beacons and probe responses. 

C. When the client CAC limit is supported, information element number 2 is sent out in the beacons and probe responses on the bg radios. 

D. When the client CAC limit is supported, information element number 1 is sent out in the beacons and probe responses on the bg radios. 

E. When only WMM is enabled, information element number 2 QBSS Load information element is sent out in the beacons and probe responses. 

Answer: D,E 


Q16. A client reports that video is not streaming. The administrator determines the client is connecting at a data rate of 12 Mbps and is trying to stream to a valid multicast address on the network. What three items should the administrator check next to troubleshoot the issue? (Choose three) 

A. IGMP snooping is turned off because the client cannot request to join a group, only access points can. 

B. Video-stream for the multicast video is configured in the controller. 

C. WLAN has been set for a QoS value of Platinum. 

D. WLAN has been configured to allow multicast-direct to work correctly and multicast-direct has been enabled globally. 

E. WLAN has been set for a QoS value of Gold. 

F. RTSP is used to stream the video due to wireless multicast not using acknowledgements. 

Answer: B,D,E 


Q17. An engineer wants to configure Call Admission Control and ensure that AC is based on the capacity of the AP and considering the possible impact of other APs in the area. Which two configuration options are required? (Choose two.) 

A. StaticCAC 

B. Admission Control 

C. Load-Based AC 

D. Add Traffic Stream 

E. Reserved Roaming Bandwidth 

F. Expedited Bandwidth 

Answer: B,C 


Q18. A customer called into the support center with a problem ticket that involves wireless clients having to reauthenticate when they are walking around their office. After further investigation, it was discovered that the customer has two controllers in an N+1 deployment. Which action must the engineer take to troubleshoot the issue? 

A. Verify that the wireless controllers are in the same mobility group and that the access points are all on the primary controller. 

B. Under the SSID, make sure that 802.1 Iris configured and running for the clients. 

C. Make sure that the SSID has the authentication set to 802.1x with Cisco Centralized Key Management so the data clients can roam seamlessly. 

D. Verify the access points are spread out between the primary and secondary controller and that the controllers are in the same mobility group. 

Answer:


Q19. A customer has implemented a wireless network that requires tuning for High Density applications utilizing the RX-SOP feature. They are experiencing a high noise floor (average of -65 dBm) and expect that to decrease significantly. A sampling of radios determine that most Access Points have neighbors on the same channel at a power level of -75 dBm. Which value should the customer use to start tuning RX-SOP? 

A. -60 dBm 

B. -65dBm 

C. -70 dBm 

D. -75 dBm 

E. -80 dBm 

Answer:


Q20. When a Vocera badge performs a broadcast call in a properly configured VoWLAN using WLC v7.0, which two choices indicate how the QoS is marked? (Choose two.) 

A. Upstream marked as Best Effort. 

B. Upstream marked as ToS CS4. 

C. Upstream marked as DSCP EF. 

D. Downstream marked as DSCP EF. 

E. Downstream marked as Best Effort. 

F. Downstream marked as Silver. 

Answer: C,E