Your success in Cisco aerospatiale alenia atr 42 300 320 is our sole target and we develop all our ccdp arch 300 320 pdf braindumps in a way that facilitates the attainment of this target. Not only is our atr 42 300 320 study material the best you can find, it is also the most detailed and the most updated. cisco 300 320 Practice Exams for Cisco CCDP cisco 300 320 are written to the highest standards of technical accuracy.

Q71. Which two of these are characteristics of multicast routing? (Choose two.) 

A. multicast routing uses RPF. 

B. multicast routing is connectionless. 

C. In multicast routing, the source of a packet is known. 

D. When network topologies change, multicast distribution trees are not rebuilt, but use the original path 

E. Multicast routing is much like unicast routing, with the only difference being that it has a a group of receivers rather than just one destination 

Answer: A,C 


Q72. DRAG DROP 

Answer: 


Q73. What is the recommended subnet between two sites that have a point-to-point connection to conserve IP addresses? 

A. 255.255.255.0 

B. 255.255.252.0 

C. 255.255.255.252 

D. 255.255.255.240 

Answer:


Q74. Which option prevents the dropping of asymmetrically routed packets in active/active failover paired firewalls? 

A. Nothing can be done to prevent this from happening. 

B. Configure different policies on both firewalls. 

C. Assign similar interfaces on each firewall to the same asymmetric routing group. 

D. Assign similar interfaces on each firewall to a different asymmetric routing group. 

Answer:


Q75. DRAG DROP 

Answer: 


Q76. Which two features can you implement to control which networks are advertised by a BGP router? (Choose two.) 

A. prefix lists 

B. route maps 

C. policy maps 

D. router SNMP statements 

E. crypto maps 

Answer: A,B 


Q77. A company has hired an entry-level network administrator for its new data center. The company CIO wants to give the administrator limited access on the newly configured Cisco Nexus 7000. Which feature should be used to allow limited access? 

A. NAC 

B. VDC 

C. RBAC 

D. vPC 

Answer:


Q78. Which two protocol characteristics should be most considered when designing a single unified fabric for the Data Center? (Choose two.) 

A. FCIP or FCoE allow for easier integration by using the Fibre Channel Protocol (FCP) and Fibre Channel framing 

B. iSCSI uses a special EtherType and an additional header containing additional control information 

C. FCIP and iSCSI has higher overhead than FCoE owing to TCP/IP 

D. FCoE was initially developed to be used as a switch-to-switch protocol, while FCIP is primarily meant to be used as an access layer protocol to connect hosts and storage to a Fibre Channel SAN 

E. FCoE requires gateway functionality to integrate into an existing Fibre Channel network 

Answer: A,C 


Q79. Which routing protocol provides the fastest convergence and greatest flexibility within a campus environment? 

A. OSPF 

B. IS-IS 

C. BGP 

D. EIGRP 

Answer:


Q80. A network engineer must perform posture assessments on Cisco ASA remote access VPN clients and control their network access based on the results. What mode is the Cisco best practice NAC deployment design for this situation? 

A. Layer 2 in-band real IP gateway mode 

B. Layer 2 out-of-band real IP gateway mode 

C. Layer 3 in-band virtual gateway mode 

D. Layer 3 out-of-band virtual gateway mode 

Answer: