Proper study guides for Regenerate Cisco Designing Cisco Network Service Architectures certified begins with Cisco atr 42 300 320 preparation products which designed to deliver the 100% Guarantee 300 320 vce questions by making you pass the cisco 300 320 dumps test at your first time. Try the free 300 320 dumps demo right now.

Q91. Which of these is a recommended practice with trunks? 

A. use ISL encapsulation 

B. use 802.1q encapsulation 

C. set ISL to desirable and auto with encapsulation negotiate to support ILS protocol negotiation 

D. use VTP server mode to support dynamic propagation of VLAN information across the network 

Answer:


Q92. Which three statements about zoning are correct? (Choose three.) 

A. Zoning increases security. 

B. DNS queries are used for software zoning. 

C. Software zoning is more secure than hardware zoning. 

D. When using zones and VSANs together, the zone is created first. 

E. Zoning requires that VSANs be established before it becomes operational. 

Answer: A,B,E 


Q93. What are two benefits of using 6to4 as an IPv6 transition method? (Choose two.) 

A. 6to4 tunnels allow isolated IPv6 domains to be remotely connected over IPv4 networks. 

B. Manual configuration (scalability) is easier. 

C. Point-to-multipoint automatic tunneling (automatic 6to4) is available. 

D. An infinite number of address spaces are allocated to an IPv6 subnet. 

E. Globally unique IPv4 addresses are not required. 

Answer: A,C 


Q94. The network engineering team is interested in deploying NAC within the enterprise network to enhance security. What deployment model should be used if the team requests that the NAC be logically inline with clients? 

A. Layer 2 in-band 

B. Layer 2 out-of-band 

C. Layer 3 in-band 

D. Layer 3 out-of-band 

Answer:


Q95. ACME corporation owns a single MDS. 

Which two SAN tools can be used to optimize the use and cost of the switching hardware? (Choose two.) 

A. zoning 

B. IVR 

C. VSAN 

D. iSCSI 

Answer: A,C 


Q96. When an enterprise network is designed, which protocol provides redundancy for edge devices in the event of a first-hop failure? 

A. ICMP 

B. HSRP 

C. STP 

D. HTTP 

Answer:


Q97. Refer to the exhibit. 

A network engineer manually reconfigures the BGP configuration on newly upgraded router R1. However, the BGP neighbor relationship does not come up with the directly connected neighbor router. What is causing the failure of the BGP neighbor relationship between routers R1 and R2? 

A. An incorrect neighbor IP address for router R2 is configured on router R1. 

B. An incorrect neighbor AS number is configured on router R1 for router R2. 

C. The wrong BGP authentication password is configured on router R1. 

D. Router R1 must configure the R2 loopback address as the neighbor IP address. 

Answer:


Q98. An engineer is designing a new data center network so that the topology maintains fewer uplinks to the aggregation layer to reduce STP processing requirements. What data center topology meets the RFP requirements? 

A. mesh 

B. top of rack 

C. star 

D. end of row 

Answer:


Q99. What is the purpose of an OTV edge device? 

A. connect to other data centers 

B. connect to the access layer 

C. connect to the end users 

D. connect to mobile devices 

Answer:


Q100. What WAN feature can prioritize real-time, IP-based applications when circuits may be saturated? 

A. FRTS 

B. LLQ 

C. CBWFQ 

D. WFQ 

Answer: