Exam Code: 300-207 (Practice Exam Latest Test Questions VCE PDF)
Exam Name: Implementing Cisco Threat Control Solutions (SITCS)
Certification Provider: Cisco
Free Today! Guaranteed Training- Pass 300-207 Exam.
Q21. What is the default IP range of the external zone?
A. 0.0.0.0 0.0.0.0
B. 0.0.0.0 - 255.255.255.255
D. The network of the management interface
Q22. Which version of AsyncOS for web is required to deploy the Web Security Appliance as a CWS connector?
A. AsyncOS version 7.7.x
B. AsyncOS version 7.5.x
C. AsyncOS version 7.5.7
D. AsyncOS version 7.5.0
Q23. Which three user roles are partially defined by default in Prime Security Manager? (Choose three.)
Q24. Which command disables SSH access for administrators on the Cisco ESA?
Q25. Which command can change the HTTPS SSL method on the Cisco ESA?
Q26. A system administrator wants to know if the email traffic from a remote partner will activate special treatment message filters that are created just for them. Which tool on the Cisco Email Security gateway can you use to debug or emulate the flow that a message takes through the work queue?
A. the message tracker interface
B. centralized or local message tracking
C. the CLI.findevent command
D. the trace tool
E. the CLI.grep command
Q27. Refer to the exhibit.
The system administrator of mydomain.com received complaints that some messages that were sent from sender email@example.com were delayed. Message tracking data on the sender shows that an email sample that was received was clean and properly delivered. What is the likely cause of the intermittent delays?
A. The remote MTA has a.SenderBase Reputation Score of -1.0.
B. The remote MTA is sending emails from RFC 1918 IP addresses.
C. The remote MTA has activated the SUSPECTLIST sender group.
D. The remote MTA has activated the default inbound mail policy.
Q28. Which three zones are used for anomaly detection? (Choose three.)
A. Internal zone
B. External zone
C. Illegal zone
D. Inside zone
E. Outside zone
F. DMZ zone
Q29. What is the default CX Management 0/0 IP address on a Cisco ASA 5512-X appliance?
Q30. Which two conditions must you configure in an event action override to implement a risk rating of 70 or higher and terminate the connection on the IPS? (Choose two.)
A. Configure the event action override to send a TCP reset.
B. Set the risk rating range to 70 to 100.
C. Configure the event action override to send a block-connection request.
D. Set the risk rating range to 0 to 100.
E. Configure the event action override to send a block-host request.