We provide real 201-450 exam questions and answers braindumps in two formats. Download PDF & Practice Tests. Pass LPI 201-450 Exam quickly & easily. The 201-450 PDF type is available for reading and printing. You can print more and practice many times. With the help of our LPI 201-450 dumps pdf and vce product and material, you can easily pass the 201-450 exam.

New LPI 201-450 Exam Dumps Collection (Question 1 - Question 10)

New Questions 1

A regular user, joe, has just run:

./configure && make && make install

to build and install a program. However, the installation fails. What could be done to install the program? (Choose TWO correct answers.)

A. Install the binaries manually with suinstall.

B. Run make install with root privileges.

C. Do not run ./configure in order to maintain the default configuration for correct installation.

D. Rerun ./configure with a --prefix option where the user has permissions to write.

E. Run make install_local to install into /usr/local/.

Answer: BD

New Questions 2

Which command is used to make an exact copy, at a single point in time, of a logical volume while still allowing the original logical volume to be updated?

A. lvcclone

B. lvcreate

C. lvm2

D. lvsnap

E. lvsnapshot

Answer: B

New Questions 3

The IDE hard drive /dev/hda does not have DMA enabled. Which command must be run to enable DMA on it?

A. hdparm -d /dev/hda

B. hdparm --dma /dev/hda

C. hdparm --dma /dev/hda1

D. hdparm -d /dev/hda1

E. hdparm -d 1 /dev/hda

Answer: E

New Questions 4

The following is an excerpt from the output of tcpdump -nli eth1 'udp': 13:03:17.277327 IP > 43653+ A? lpi.org. (25)

13:03:17.598624 IP > 43653 1/0/0 A (41)

Which network service or protocol was used?






Answer: D

New Questions 5

Considering the following kernel IP routing table below, which of the following commands must be used to remove the route to the network (Select TWO answers)

Kernel IP routing table

Destination Gateway Genmask Flags Metric Ref Use Iface UH 0 0 0 ppp0 U 0 0 0 eth0 U 0 0 0 eth1 UG 0 0 0 eth1 U 0 0 0 lo UG 0 0 0 ppp0

A. ip net delete B. route del

C. route del -net

D. route del gw

E. ip route delete

Answer: CE

New Questions 6

Which of the following files are used to resolve hostnames to IP addresses? (Choose TWO correct answers.)

A. /etc/systems

B. /etc/hosts

C. /etc/network

D. /etc/dns.conf

E. /etc/resolv.conf

Answer: BE

New Questions 7

Which of the following commands shows capabilities and usable frequencies for the wireless interface wlan0?

A. iw phy pyh0 info

B. iw dev wlan0 info

C. iw dev wlan0 show

D. iw phy wlan0 show

E. iw phy0 show

Answer: A

New Questions 8

What does the -p3 option to the patch command do?

A. It will strip off path information from each file mentioned in the patch file up to and including the third / character.

B. patch continues execution as long as there are three or fewer errors.

C. It instructs patch to look up to three lines of context before or after the declared line in the original file for a match.

D. patch will keep three previous versions of each file in the output to prevent loss of change history.

E. It instructs patch to conform more strictly to the POSIX standard.

Answer: A

New Questions 9

What action should be performed after increasing the size of a logical volume?

A. Run vgresize.

B. Increase the size of the filesystem used for the logical volume.

C. Run lvresize.

D. Remount the logical volume.

Answer: B

New Questions 10

When a makefile is included in a source code package, what are commonly defined targets in the file?


B. clean, install, uninstall


D. prefix, exec_prefix, bindir, mandir

Answer: B

Recommend!! Get the Breathing 201-450 dumps in VCE and PDF From 2passeasy, Welcome to download: https://www.2passeasy.com/dumps/201-450/ (New Q&As Version)