Proper study guides for Far out Cisco Implementing Cisco Wireless Network Fundamentals certified begins with Cisco ccna wireless 200 355 official cert guide preparation products which designed to deliver the Verified 200 355 vce questions by making you pass the ccna wireless 200 355 test at your first time. Try the free ccna wireless 200 355 official cert guide pdf free download demo right now.
Q191. RAG DROP
Q192. What is the approximate time difference for a client to perform an intracontroller roam compared to an intercontroller roam?
A. 1 ms
B. 10 ms
C. 20 ms
D. 30 ms
Q193. What three characteristics are components of mobility anchoring? (Choose three.)
A. enabled as a global setting
B. enabled on a per WLAN basis
C. restricts clients to a specific subnet
D. client traffic is tunneled to predefined WLC(s)
E. only one mobility anchor is allowed per WLAN
F. acts as master controller for a mobility group
Q194. Which IEEE 802.11n client feature can combine the signal from multiple antennas and radio chains to improve SNR?
A. channel aggregation
B. spatial multiplexing
C. MAC layer efficiency
Q195. Refer to the exhibit.
Which menu gives you access to manage background tasks in Cisco WCS?
A. None, because the General tab provides access to the management of background tasks
Q196. Refer to the exhibit.
Cisco WCS version 7.0 has a configuration mismatch with what is actually running in the controller. Which menu leads to the Audit Status Report?
Q197. An engineer is adding a controller to a WCS. What three categories of parameters are needed? (Choose three.)
A. IP parameters
B. SNMP Parameters
C. Mobility Parameters
D. Telnet/SSH Parameters
E. TFTP Parameters
F. RADIUS Parameters
Q198. What authentication method requires a certificate on both the client and authentication server?
Q199. Which CAPWAP AP management-access method is available as the default setting?
A. only the console port
B. the console port and SSH
C. the console port, SSH, and HTTPS
D. SSH only
Q200. Which two statements best describe the LAG configuration between a Cisco WLC and a Cisco Catalyst switch? (Choose two.)
A. The Catalyst switch should be configured for PAgP.
B. The Catalyst switch should be configured only for Layer 2 load balancing.
C. The Catalyst switch should be configured for "on" mode.
D. The Cisco WLC relies on the connected switch to perform the load-balance of traffic.
E. The Cisco WLC aggregates multiple management interfaces into a single virtual interface.