Q131. Refer to the exhibit. A network administrator is attempting to connect to the GUI of a WLC with interfaces as shown. Which IP address should the network administrator use?
Q132. The results of a Cisco WCS client troubleshooting tool are summarized into a simple visual representation of a four-part progression of the connection status for a wireless client.
What are the four parts? (Choose four.)
A. client MAC address
B. 802.11 authentication
C. IP address assignment
D. 802.11 association
E. successful association
F. authentication method
H. client radio type
Q133. What are the three primary functions of the Cisco Unified Wireless LWAPP architecture? (Choose three.)
A. control and management of the CAPWAP
B. tunneling of VPN clients over the WAN
C. tunneling of WLAN client traffic to the WLC
D. collection of 802.1Q trunks
E. collection of 802.11 data for management
F. control and management of VTP
Q134. Which three items do you need to establish a wireless connection to an enterprise wireless network? (Choose three.)
A. SSID name
B. RF channel
C. RF signal
D. 802.1X/EAP credentials
E. pre-shared key
F. web page
G. WPA/WPA2 settings
Q135. An engineer needs to find out the maximum EIRP allowed for their office in Asia. What regulatory body should be contacted?
Q136. What two capabilities would be present on a wireless client device that supports CCXv3? (Choose two.)
Q137. What two access methods are enabled by default on a Cisco WLC? (Choose two.)
Q138. A customer wants to deploy a mesh network with 2 root access points and 10 mesh access points. The root access points should be configured as which mode on the WLC?
D. rouge detection
Q139. RAG DROP
Q140. An engineer is conducting an active survey for indoor coverage in a warehouse. The warehouse has long aisles with racks that extend to the ceiling. Which antenna type has a radiation pattern that is suited to provide coverage in each aisle?