Your success in Cisco 200 310 desgn is our sole target and we develop all our ccda 200 310 braindumps in a way that facilitates the attainment of this target. Not only is our ccda 200 310 pdf study material the best you can find, it is also the most detailed and the most updated. ccda 200 310 pdf Practice Exams for Cisco CCDA ccda 200 310 dump are written to the highest standards of technical accuracy.

Q111. When evaluating network designs, what indicator demonstrates that the modular approach was followed? 

A. ability to scale 

B. follows best practices 

C. redundant connectivity 

D. easy to deploy 

Answer:


Q112. OSPF will be used as the IGP within a campus network. Which two things should you consider before deployment? (Choose two.) 

A. All areas need to connect back to area 0. 

B. The OSPF process number on each router should match. 

C. NSSA areas should be used when an area cannot connect directly to area 0. 

D. Stub areas should be connected together using virtual links. 

E. ECMP may cause undesired results depending on the environment. 

Answer: A,E 


Q113. By default, how does EIGRP's metric differ from OSPF? 

A. hops 

B. cost 

C. bandwidth 

D. delay 

Answer:


Q114. Which three options represents the components of the Teleworker Solution? (Choose three.) 

A. Cisco Unified IP Phone 

B. Cisco 880 Series Router 

C. Aironet Office Extend Access Point 

D. Catalyst 3560 Series Switch 

E. Cisco 2900 Series Router 

F. MPLS Layer 3 VPN 

G. Leased lines 

Answer: A,B,E 


Q115. Which technology enables WLCs to peer with each other to enable roaming support? 

A. WAP profiles 

B. roaming profiles 

C. mobility groups 

D. peer.groups 

Answer:


Q116. What three primary sources of information are needed to perform a network audit? (Choose three.) 

A. existing documentation 

B. new documentation 

C. existing network management software 

D. new network management tools 

E. management personnel 

F. technical personnel 

Answer: A,C,D 


Q117. Which protocol is used to reserve bandwidth for the transport of a particular application data flow across the network? 

A. cRTP 

B. IEEE 802.1P 

C. RSVP 

D. LFI 

E. Auto QOS 

Answer:

Explanation: 

RSVP Signaling protocol that enables end stations or applications to obtain guaranteed bandwidth and low delays for their data flows. 


Q118. What are the three modes of unicast reverse path forwarding? (Choose three.) 

A. strict 

B. loose 

C. VRF 

D. global 

E. PIM 

F. local 

Answer: A,B,C 


Q119. A network engineer must implement a design where LAN clients are to connect.to various access layer devices, while remaining on the same VLAN . What type of design would support this requirement? 

A. routed 

B. switched 

C. tunneled 

D. virtual 

Answer:


Q120. Refer to the exhibit. On which router should you configure redistribution? 

A. Router 1 

B. Router 2 

C. Router 3 

D. Router 4 

E. Router 5 

Answer: